Selecting Tuner Band
1.PressSOURCEto select TUNER.
2. PressBAND to select between AM or FM radio
band.
¸II II¸II; I;I¸ii;i!!!ii i
Tuning to a Station
PressSKIPRACKWARD _ /FORWARD _
onthemainunitorTUNEREW _ /IUNEFFWD
on the remote control to select frequencies.
AutoPresetProgramming(forFMonly)
Pressand hold RANDIAUTO PROG. button for 2sec-
onds to scan stations in FM band. The stations will
then be stored as preset channels. A maximum 32 sta-
tions can be stored. Beware of your preset channels
being erased accidentally becausethe scanning and
storing processisautomatic upon pressing and hold-
ing the button. You can stop the automatic scan by
pressingany button, but the erased stations cannot be
recovered.
ManuallySettingPresets
1.PressTUNE/PRESETbutton to enter TUNE mode.
2. PressSKIP RACKWARD _ /SKIPFORWARD
•_ to accessthe desired frequency.
3. Pressthe PROG/SETbutton once.
4.The most recently accessedprogram locationwill
be displayed.
5. If adifferent program location ispreferred, press
SKIPRACKWARD _ ISKIPFORWARD _
to move to the desired preset number (I-32).
6. PressPR_ET to store the selected frequency at
that preset.
Using Presets
The tuner can be in either TUNEor PRESETmode.
When in PRESETmode, the PROGlight ison.
• PressTUNE/PRESETon the main unit to toggle
TUNEand PRESETmode.
• Press SKIP BACKWARD _ orSKIP
FORWARD _ _ on the main system or
PRESETPREV _ or PRESETNEXT _ on the
remote control to accessthe previous or next
preset station. The display first shows the preset
program number and after a few seconds,the
frequency will be displayed. (FMPR:01is FM
preset I )
Suppressing Stereo Signal
PressCD DISPLAY/FM STto toggle between FM
mono and stereo for stereo FMstations.
To Next Page
Loading...
Need help?
General
