Operating Your Receiver
EN
13
Switching on/off
• To switch on the receiver, press ON/STANDBY
button once, or any source button on the remote
control.
• Standby: when the receiver is on, press the
ON/STANDBY button once to activate the standby
mode.
• To switch off the unit completely, unplug the
power cord from the socket
Selection of Audio/Video source
When one of the source buttons is pressed, the audio
and video input corresponding to the name will be
activated.
The receiver acts as a switching device between all
the sources that are plugged into it.
Example 1:
If you connect a DVD player to the DVD input
(audio + video) on the receiver and press the DVD
button, or press source button repeatedly until
DVD is selected, you will be able to have the sound
and image transmitted by the DVD.
Example 2:
Based on the example 1, the DVD is playing , if a
VCR is connected to the VCR 1 input (audio +
video) of the receiver, press the VCR button , or
press source button repeatedly until VCR is select-
ed, image and sound from the VCR source will
replace the DVD.
To Next Page
Loading...
Need help?
General
