3
Programming a Device using CODE SEARCH
1. Manually turn on your device
(TV, VCR, Laserdisc Player, Satellite
Receiver, Cable Box or Audio Equipment).
2. Press and hold CODE•SRCH.
3. Press and release the device button you
want to set up (TV, VCR1, VCR2•LD,
SAT•CABLE, or AUDIO).
4. Release CODE•SRCH.
5. Press POWER repeatedly until the device
turns off (you may have to press up to
100 times).
6. Once the device turns off,
press and release ENTER.
7. With the device on, press another button,
for example CHANNEL UP. If the device
responds, no further programming is
required. If the device does not respond,
repeat steps 1-7.
Programming Your Universal Remote
The remote may already be set up to operate your brand of TV, VCR, Laserdisc,
Satellite Receiver, Audio Equipment, or Cable Box. It is pre-programmed with the
following codes: TV-000, VCR1-000, AUDIO-003, and SAT•Cable Box-000. For
brands that require programming, there are two ways to program: Using Code
Lists or Code Search. Use Code Search if the code lists are not available or if the
codes from the lists do not operate a device.
T
V
V
C
R
2
•
L
D
V
C
R
1
S
A
T
•
C
A
B
L
E
A
U
D
I
O
PRESS
& HOLD
RELEASE
To Next Page
Loading...
Need help?
General
