connections
41
Choosing a VCR Connection
There are several different ways to hook up your VCR, depending
on whether or not you have cable, and if you have cable, whether
you have a cable box, and if some of the channels are scrambled
and...well, you get the picture.
Three connections are described in this section and one of them
should provide you with a VCR hookup that works.
• TV with RF Jack only
• TV with audio/video jacks
• TV with audio/video jacks and cable box to unscramble pay
channels only
If you need to hook up additional components not shown in the
diagrams here (and are unsure of how to connect them), refer to
the instruction manual that came with that particular component.
Advantages of Audio/Video
Cable Connections
Using a simple antenna cable connection gives you good picture
quality. If your television has A/V jacks, I highly recommend using
them to get even better picture and stereo sound when recording
and playing back videotapes. These connections give you more
convenient operation by not having to share the signal from the
antenna cable.
Don’t Forget About the Auto
TV/VCR Feature
The TV/VCR switch controls whether the picture signal is coming
from the VCR or the TV. You can change the setting manually by
using the TV•VCR button on the remote, or you can set the Auto
TV/VCR feature to automatically switch to VCR mode when the
VCR is turned on. Set the Auto TV/VCR feature to ON when using
only RF ANTENNA connections and OFF when using the A/V
output jacks—so your TV signal is not interrupted when the VCR
is turned on.
To Next Page
Loading...
Need help?
General
