QXBIUDB*T[G3DJH
MEGANE SCENIC MONOSPACE NU 641-1
C:\Documentum\Checkout\nu641-1_eng_T2.WIN 21/2/2001 11:43
-page6
2.06
GEAR LEVER HANDBRAKE POWER STEERING
To select reverse
(vehicle stationary)
Move the lever to neutral, then
position the lever in reverse.
Ring 1 has to be lifted up to the gear
lever knob to select reverse gear.
The reversing lights will illuminate
as soon as reverse gear is selected
(ignition on).
To release:
Pull the lever up slightly, press
button 2 and then lower the lever to
the floor.
Theredwarninglightonthe
instrument panel will illuminate if
you are driving with an incorrectly
released handbrake.
To apply:
Pull the lever up.
The lever should travel about 10
notches to hold the car. Your vehicle
is fitted with self-adjusting rear
brake shoes and the handbrake
should only be adjusted during a
brake overhaul.
When the vehicle is
stationary, make sure
that the handbrake is
properly applied so that
the vehicle does not move
unintentionally.
Make sure the handbrake is
properly released when driving,
otherwise overheating may
occur.
When power assisted steering is
fitted, never leave the steering
wheel on full lock when the vehicle
is parked as this may damage the
pump.
Never switch off the
ignition when travelling
downhill, and avoid
doing so when driving in
general (power steering and
brake servo will not function).
To Next Page
Loading...
Need help?
General
