Renogy Wanderer 30A User Manual

2
Important Safety Instructions
Please save these instructions.
This manual contains important safety, installation, and operating instructions for the
charge controller. The following symbols are used throughout the manual:
WARNING: Indicates a potentially dangerous condition. Use extreme caution
when performing this task.
CAUTION: Indicates a critical procedure for safe and proper operation of the
controller
NOTE: Indicates a procedure or function that is important to the safe and proper
operation of the controller.
General Safety Information
• Read all of the instructions and cautions in the manual before beginning the
installation.
• There are no serviceable parts for this controller. Do NOT disassemble or attempt
to repair the controller.
• Make sure all connections going into and from the controller are tight. There may
be sparks when making connections, therefore, make sure there are not flammable
materials or gases near installation.
Charge Controller Safety
• NEVER connect the solar panel array to the controller without a battery. Battery
must be connected first. This may cause a dangerous occurrence where the
controller would experience a high open circuit voltage at the terminals.
• Ensure input voltage does not exceed 25 VDC to prevent permanent damage. Use
the Open Circuit (V
oc
) to make sure the voltage does not exceed this value when
connecting panels together in series.
• The charge controller should be installed indoors in a well-ventilated, cool, and dry
environment.
• Do NOT allow water to enter the controller.

Renogy Wanderer 30A Specifications

General

Brand	Renogy
Model	Wanderer 30A
Category	Inverter
Language	English