English9 English 10
Specifications
Power: By PoE (802.3af)/DC 12V
Spotlight: 1pcs
Day/Night Mode: Auto Switchover
Operating Temperature: -10°C to 55°C (14°F to 131°F)
If the spotlight on your camera is not on, please try the following solutions:
• Ensure the spotlight is enabled under Device Settings page via Reolink App/Client.
• Upgrade the firmware of your camera to the latest version.
• Restore the camera to factory settings and check out the spotlight light settings again.
Hardware Features
General
Spotlight is not On
Troubleshooting
If your camera is not powering on, please try the following solutions:
• Make sure your camera is powered properly. The PoE camera should be powered by a PoE switch/
injector, the Reolink NVR or a 12V power adapter.
• If the camera is connected to a PoE device as listed above, connect the camera to another PoE
port and see if the camera will power on.
• Try again with another Ethernet cable.
If the picture from the camera is not clear, please try the following solutions:
• Check the camera lens for dirt, dust or spiderwebs, please clean the lens with a soft, clean cloth.
• Point the camera to a well-lit area, the lighting condition will aect the picture quality a lot.
• Upgrade the firmware of your camera to the latest version.
• Restore the camera to factory settings and check out again.
Camera is Not Powering On
Picture is not Clear
To Next Page
Loading...
Need help?
General
