Camera is not Powering on
For PoE Camera
Troubleshooting
If your camera is not powering on, please try the following solutions:
• Make sure your camera is powered on properly. The PoE camera
should be powered by a PoE switch/injector, a Reolink NVR or a 12V 2A
power adapter.
• If the camera is connected to a PoE device as listed above, connect it to
another PoE port and check again.
• Try again with another Ethernet cable.
For WiFi Camera
• Camera only supports one power extension cable, do not use two
extension cables.
• Plug the camera into a dierent outlet and see if it works.
• Power on the camera with another working 12V 2A DC adapter and see
if it works.
English
English
To adjust the camera direction, you may control the camera
to pan and tilt via Reolink App or Client.
3
PTZ
9 10