TM031 Integrity 18, 20, 24, 26L Service Instructions REV: B
D.O.I: February 2008
This document is stored and maintained electronically by Service. All printed copies not bearing this statement in RED are deemed “uncontrolled”
Exploded View 2 Replacement Parts List – 871024 Models
Silicone Tube (Insulator)
Silicone Tube (Insulator)
Anti-Frost Heater (Heater A) (Anti-frost models only)
Anti-Frost Heater (heater B) (Anti-frost models only)
Anti-Frost Heater Clamp (Anti-frost models only)
Anti-Frost Heater “C” Clamp (Anti-frost models only)
Anti-Frost Heater Clamp (Anti-frost models only)
Ambient Air Temp Thermistor Assy
Outlet Thermistor (Thermistor B)
Anti-frost Thermostat Assembly (Anti-frost models only)
Heat Exchanger (HX) Thermistor
Hall Effect I.C. Assembly
Signal Loom (inc amb air & HX thermistor)
Noise filter holder assembly
Fuse - In line Note: PCB fuses not fitted
240 -110 Volt Transformer Assembly
Gas Conversion Kit - LP to NG
Gas Conversion Kit - NG to LP
*When installed in an 871024, 871024-B or 871024-C model heater these parts will require the
replacement of other interconnecting components. Refer to „Product Changes‟ on page 10 and
„Parts Replacement Scenarios‟ on page 11 for more information.
Note: For controller and controller cable part numbers refer to page 20
To Next Page
Loading...
Need help?
General
