5
TM061 Rheem 27 Water Star Service Instructions – Issued: 11/10
REV A Issued 08/13
This document is stored and maintained electronically by Service. All printed copies not bearing this statement in RED are deemed “uncontrolled”
SPECIFICATIONS
Max Flow Rate @ 25°C Rise (L/M)
Max Flow Rate @ 40°C Rise (L/M)
Injector Orifice (qty x dia mm)
Burner Test Point Pressure (kPa)
Min Inlet Gas Pressure (kPa)
Max Inlet Gas Pressure (kPa)
Storage Tank Relief Valve Setting (kPa)
Heater Relief Valve Setting (kPa)
2 x 5A Fuse (line voltage), 5A fuse on power supply PCB
Over Heat Limiter for Heat Exchanger
Heat Exchanger Thermistor (Boiling Point Safety)
T&PR Valve (HT55 1000kPa)
-20°C (Without Wind-Chill Factor) with power applied
(1)
Maximum power consumption with heater running and anti-frost heaters energized.
(2)
Maximum power consumption with element operating.