HEAT EXCHANGER
INTEGRATED
FURNACE
CONTROL
DIRECT SPARK IGNITOR
WITH REMOTE SENSE
IN-SHOT BURNERS
DRAFT INDUCER MOTOR
Air
Standard & Optional Equipment
R801T (DF) Series
3
STANDARD EQUIPMENT
Completely assembled and wired; induced draft; pressure
switch; redundant main gas control; blower compartment door
safety switch; solid state time on/time off blower control; limit
control; manual shut-off valve, pressure regulator for natural
and L.P. (propane) gas; transformer; direct drive multi-speed
blower motor. Furnaces are equipped with cooling/heating
relay and transformer (40VA) ready for air conditioning
applications. (Please note: a thermostat is not included as
standard equipment.) Flame sensor diagnostics; on-board
twinning; fused-protection (secondary), 3rd speed option for
continuous fan; common heat/cool terminal.
OPTIONAL EQUIPMENT
NOTE: Furnace is not listed for use with fuels other than
natural or L.P. (propane) gas.
The complete terms of limited and other warranties are
available at our sales office, or through local installer.
All models can be converted by a qualified Rheem distributor
or local service dealer to use L.P. (propane) gas without
changing burners. Factory approved kits must be used to
convert from natural to L.P. (propane) gas and may be ordered
as optional accessories from a Rheem parts distributor.
For L.P. (propane) operation, refer to Conversion Kit Index Form.
NOTE: For natural and L.P. (propane) gas models, direct spark
ignition is 100% lockout type.
WARNING
THIS FURNACE IS NOT APPROVED
OR RECOMMENDED
FOR USE IN MOBILE HOMES
CONSTANT TORQUE ECM MOTOR
To Next Page
Loading...
Need help?
General
