10
b. Water pipe connection
The inlet and outlet water unions are to be connected by approved PVC pipes used for pool &
spa plumbing!
• DO NOT install water pipes in a way that they pass behind the heat pump's evaporator coil. If this
cannot be avoided, ensure the pipes are covered with thermal insulation.
2. Wiring
a. Connect this device to an appropriate power supply, the voltage should comply with the rated voltage of
the product.
b. Earth the machine well.
c. Wiring must be handled by a professional electrician according to the circuit diagram.
d. Set leakage protection according to the local authority for wiring (i.e.: leakage operating current ≤ 30mA).
e. The laying of power and signal cables should be such that they do not affect each other.
To Next Page
Loading...
Need help?
General