14
f. Defrost
1)
Automatic defrosting: When the unit is in auto defrosting mode this symbol will flash until it is
finished. Once finished it will go back to normal operating mode.
2)
Manual Defrost: To enter the forced defrosting mode, the compressor must have been operating for
more than 10 minutes.
In heating mode, press and on buttons together simultaneously for 5 seconds to start the
forced defrost mode and this symbol is flashing the defrost function starts. Once stops
flashing the defrosting mode stops and the unit will resume normal operation.
(Note: the intervals between forced defrosting should be more than 30 minutes)
g. Wi-Fi Setting
When the screen is on, press for 3 seconds, when this symbol starts to flash, enter the
Wi-Fi connection.
Connect the Wi-Fi on your mobile device and input the password, and then control
equipment by Wi-Fi. When the Wi-Fi APP successfully connects the Wi-Fi symbol light stays
on.
h. Running Status Checking
1) Press symbol for 5 seconds, the unit will then start to run the checking status
2)
During this time, the display will show the status symbol “C0” and its corresponding value.
3) Change status by pushing the and arrows to the corresponding value.
4) Press to quit the “Running Status Checking” mode.
5)
Running status checking table:
To Next Page
Loading...
Need help?
General