17
INSTALLATION INSTRUCTIONS
General
Product Inspection
Visually inspect the water heater for any possible
damage.
Check the rating plate on the water heater to make
sure the water heater was designed to be used with
the supplied type of gas (natural or LP).
Verify that all included supplied parts are present as
shown.
Water Heater Installation
Corrosive Atmosphere
NOTICE:
The water heater should not be installed near an air supply
containing halogenated hydrocarbons where contaminants
can enter the combustion air supply.
Avoid installing a water heater in any of the
following locations: beauty shops, dry-cleaning
establishments, photo processing labs, and storage
areas for liquid and powdered bleaches or swimming
pool chemicals. These locations often contain such
halogenated hydrocarbons.
The air supply containing halogenated hydrocarbons
is safe to breathe, but when passed through a gas
flame, corrosive elements are released that will
shorten the life of any gas-burning appliance.
Propellants from common spray cans or gas leaks
from A/C and refrigeration equipment are highly
corrosive after passing through a flame.
NOTICE:
The water heater warranty is void when the failure is due to
operation in corrosive conditions.
Screws
Washers
Mounting Bracket
Pressure Relief Valve
(Some models only)
To Next Page
Loading...
Need help?
General
