Rheem RTGH-95DVLN-3 User Manual

62
Water Saving Control
Water saving control is optional and is inactive
as default. To activate this control, appropriate
procedures must be followed.
Water saving control can reduce waste water at
initiation of hot water demand by reducing flow until
outlet hot water reaches set temperature.
It is recommended to turn ON this control if the
water heater is installed in a drought area or
anywhere water conservation is needed.
Follow the steps below to turn ON the water saving
control.
1
Turn off the gas and water to the water heater by
closing the shut-off valves.
2
Remove the front cover panel on the water heater
and ensure the remote is OFF.
Find DIP Switch 1 located in the top-right portion at
the control board. The switch labeled “DIP 1” is the
right-most set of switches. If any DIP switches are
on for venting/altitude settings, switch them to the
OFF position.
Change the third switch on “DIP 1” to the ON
position (UP).
Within 30 seconds of turning the third switch ON,
press the "Max button" or "Min button" on the
control board to set the activation of this control.
LED display on the built-in control shows “oF”.
Within the next 30 seconds, the display/control
board will show the water saving control setting. The
LED identifications are below
ON
1 2 3 4
ON
1 2 3 4
DIP 1
DIP 2
4
Start/Adjust
3
DIP Switch
Control Board
6
ON
1 2 3 4
ON
1 2 3 4
DIP
Switch
2
"MAX"
button
"ADJUST"
button
"MIN"
button
DIP
Switch
1
5
WATER SAVING
CONTROL
CONTROL BOARD LED
(RED)
DISPLAY LED
ON Once Flashing ON
OFF Twice Flashing OF
USING YOUR WATER HEATER

Rheem RTGH-95DVLN-3 Specifications

General

Brand	Rheem
Model	RTGH-95DVLN-3
Category	Water Heater
Language	English