Programs
137
6
Registering Initial Values for Initial Display
This section explains how to set defaults for the initial screen, which appears
when the machine is turned on or when settings are cleared or reset.
The following settings can be registered as defaults: Scan Settings, 1 Sided /2
Sided Original, Top to Top/Top to Bottom, skip scanning back side of the last
page, Divide, Original Orientation, File Type, Batch / SADF, Stamp, Store File,
Preview, and Reception Notice.
A Make the necessary scan settings on the initial screen.
B Press {Program}.
C Press [Program as Defaults].
D Press {Program}.
E A confirmation screen appears. Press [Yes].
The current settings are registered as defaults, and then the initial screen re-
appears.
Note
❒ To restore the initial screen's original default settings, press [Restore Factory
Defaults].
❒ Default settings for the initial screen can be registered for normal screens
and simplified displays respectively.
AMW013S
To Next Page
Loading...
Need help?
General