Ricoh MP C4503 Technical Bulletin

Technical Bulletin PAGE: 3/5
Reissued: 27-Dec-16
Model: MET-C1ab, MET-C1ab_SOP
Date: 18-Jun-13
No.: RD147001w
Version
Modified Points or Symptom Corrected
- JAM1 (internal finisher SR3180)
Conditions: The following sequence is repeated.
Job 1: Edge stapling (1 spot) with 2 sheets of DLT paper
Job 2: DLT paper (1 sheet) is exited to the 1-bin tray
Job 3: Same as Job 1
1.30:08
Symptom corrected:
1. An image issue occurs when copying at 87% onto B4 paper with ADF scanning of
nonstandard sizes.
2. A staple issue occurs where the first set is stapled correctly, but the first sheet after
that is discharged (with the rest being stapled).
Ex., a job with 3 A4 sheets copied into three sets using stapling.
Other changes:
3. New software control to clearly identify/distinguish toner color bottles.
4. The following SP defaults were changed to "-1", in order to prevent pre-stacking
alignment issues.
SP6-116 : Adjusts max pre-stack sheets count when edge stitching specified
paper
-003 (A4SEF)
-005 (B5SEF)
-009 (LTSEF)
-012 (16KSEF)
1.29:08
Spec changes:
Firmware modification (Engine and System/Copy) so that the power line (24V) is shut
down when detecting the layer short-circuit and SC code is displayed.
Note:
SC666 has been newly added. Depending on the sub code of SC666, the action is
different as follow.
SC666-01 ：PCB:IOB:ENGINE
SC666-02/03 ：PCB:IOB:TRANSPORT
SC666-00 ：Both PCB:IOB:ENGINE and TRANSPORT
IMPORTANT: To apply the above changes, update this firmware together with
System/Copy.
System Copy Ver. 1.12 (D1475550) or newer for MP C3003/MP C3500
System Copy Ver. 3.03 (D1465550) or newer for MP C3003/MP C3500 with Smart
Operation Panel.
1.28:08
Error Correction:
1. Noise is generated by the paper pick-up solenoid.
1.27:08
Symptom corrected:
1. SC552 (SC545) occurs if the machine enters Sleep mode and is then immediately
brought out/recovers.
1. SC552 or SC545 occurs if the machine is brought out of Energy Saver mode right
after entering the mode.
Note: SC552 occurs if the fusing temperature is below 80C when recovering, and
SC545 occurs if the fusing temperature is 80C or higher.
2. A FAX job stalls (communicating lamp stays lit) if a network printing job is received

Ricoh MP C4503 Specifications

General

Brand	Ricoh
Model	MP C4503
Category	All in One Printer
Language	English