Ricoh MP C4503 - Page 154

Technical Bulletin PAGE: 1/2
Reissued: 21-Nov-14
Model: MET-C1ab_SOP/ MET-C1cde_SOP/ MET-C1yz_SOP/
Cor-C1_SOP/OR-C2_SOP/Z-C2_SOP
Date: 15-Nov-13
No.: RD147072h
RTB Reissue
The items in bold italics have been corrected or added.
Subject: Firmware Release Note: SimpleCopy for eDC
Prepared by: N. Yoshida
From: 1st Tech Service Sect., MFP/Printer Tech Service Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Product Safety
Part information
Electrical
Transmit/receive
Other (Firmware)
Action required
Service manual revision
Retrofit information
Tier 2
Important Information about Normal/Smart Panel Firmware Updates
 When updating machine firmware, make sure NOT to install Smart Panel supported
firmware on a machine with a normal operation panel (and vice-versa). If you do, the
machine may not function as designed and product warranty may not apply.
 To avoid this, when updating the firmware, make sure that the numbers next to "NEW" and
"ROM" are the same on the operation panel.
 If you install the wrong firmware, repeat the update procedure and check the numbers
mentioned above.
This RTB has been issued to announce the firmware release information for the SimpleCopy for
eDC.
Version
Program No.
Effective Date
Availability of RFU
1.17
D1501445H_forEDC
October 2014 production
Not Available
1.16
D1501445G_forEDC
June 2014 production
Not Available
1.14
D1501445F_forEDC
March 2014 production
Not Available
1.13
D1501445E_forEDC
December 2013 production
Not Available
1.12
D1501445D_forEDC
November 2013 production
Not Available
1.11
D1501445C_forEDC
October 2013 production
Not Available
1.10
D1501445B_forEDC
Initial release
Not Available
Note: Definition of Availability of RFU via @Remote
“Available”: The firmware can be updated via RFU or SD card.
“Not available”: The firmware can only be updated via SD card.
Version
Modified Points or Symptom Corrected
1.17
Symptom corrected:
1. The Smart Operation Panel stalls when the machine recovers from Energy Saver
mode if the user booted up Simple Copy from the app. history list when the
machine entered Energy Saver.
2. The following error message is displayed if the user boots up Simple Copy just
after the machine enters Energy Saver mode:
"Cannot make copies. The function selected cannot be configured. Please try
again."
1.16
Symptom corrected:
1. The Copy zoom setting was changed from 「82% A4->B5 B4->B5」 to 「82% B4->A4 B5-
>A5」.