• Do not turn off the power while the printer is in operation.
1. Push the main power switch.
The main power is turned off automatically when the shutdown process is complete.
If the shutdown process is not complete within the period of time displayed on the screen, contact
your service representative.
Saving Energy
This printer has the following energy saving functions:
Low Power mode
If the printer is not used for a certain period of time, it enters Low Power mode.
In Low Power mode, the printer consumes less electricity than in the standby mode by turning off the
display and lowering the temperature of the fusing unit heater. If the printer receives a job, it
increases the temperature of the fusing unit and perform printing, but the display remains off.
You can configure the period of time the printer waits before it enters Low Power mode in [Low
Power Mode Timer]. For details, see "System", Operating Instructions.
To exit Low Power mode, do one of the following:
• Start print jobs
• Press any key on the control panel
• Open any cover
• Open any paper tray
The printer also exits Low Power mode when the ECO Night Sensor detects an increase in the
ambient light level.
Fusing Unit Off mode
If you do not use the printer for a certain period after an operation, the display will turn off and the
printer goes into Fusing Unit Off mode. The printer uses less electricity in Fusing Unit Off mode.
1. Getting Started
18
To Next Page
Loading...
Need help?
General
Weight and Dimensions
