RIGOL
10 DL3000 Quick Guide
To Power on the instrument
After the instrument is connected to the power source, press the Power key
at the left bottom of the front panel to power on the instrument. When the
instrument is turned on, it will undergo a self-test. If the instrument passes the
self-test, the welcome interface is displayed; otherwise, self-test failure
information will be displayed. At this time, please contact RIGOL distributors.
CAUTION
Ensure that the AC selector setting on the rear panel of the
instrument matches the actual AC input voltage, otherwise, the
electronic load will be burned out.
CAUTION
Please pay attention to the positive and negative polarities of the
electronic load to avoid wrong connection. Otherwise, the load
will be burned out.
Tip
After powering off the electronic load, please wait for at least 1 s before you
power it on again.
To Next Page
Loading...
Need help?
General
