Rinnai Continuum Series User Manual

REU-2532FFU Series 14 Rinnai
8. SPECIFICATIONS
Rinnai model number REU-V2532FFU-US REU-V2532FFU(C)-US
Type of appliance Temperature controlled continuous flow gas hot water system
Operation With / without remote controls, mounted in kitchen, bathroom, etc.
Exhaust system Direct Vent - Forced combustion
Maximum/Minimum gas rate (Input BTU's)
180,000 BTU's - 15,000 BTU's Natural Gas
180,000 BTU's - 15,000 BTU's Propane Gas
Hot water capacity, (50°F rise) 0.5 to 6.5 GPM
Maximum hot water capacity, (35°F rise) 8.4 GPM
Setpoint Temperature (without remote) Factory setting - 120°F Factory setting - 140°F
Temperature range (with remote)
MC controller : 96 - 140°F
BC controller : 96 - 120°F
BSC controller : 96 - 120°F
MCC controller : 96 - 180°F
Approved gas type Natural or Propane - Ensure unit matches gas type it's being installed on.
Installation Indoor Only
Dimensions
Height 23 5/8"
Width 13 25/32"
Depth 8 13/16"
Weight 49 Lbs.
Thermo Efficiency rating 0.87 (Propane) 0.82 (Natural)
Noise level 49 dB (A)
Connections
Gas supply 3/4" MNPT
Cold water inlet 3/4" MNPT
Hot water outlet 3/4" MNPT
Ignition system Direct electronic ignition
Electrical consumption
Normal 75 watts
Standby 5.5 watts
Anti-frost protection 100 watts
Water temperature control Simulation feedforward and feedback.
Water flow control
Water flow sensor, electronic water control device, and electronic by-pass control
device
Recommended Minimum water
supply pressure
20 PSI (Rinnai recommends 50-80 PSI for maximum performance)
Maximum water supply pressure 150 PSI

Rinnai Continuum Series Specifications

General

Brand	Rinnai
Model	Continuum Series
Category	Water Heater
Language	English