Rittal CMC III Processing Unit User Manual

Rittal CMC III Processing Unit / CMC III Processing Unit Compact 11
EN
6 Network settings
 Connect the device with a network cable using the Ethernet interface to your computer (fig. 3,
item 11).
 Change the IP address of your computer to any address in the range 192.168.0.xxx, e.g.
192.168.0.191. The default address 192.168.0.190 of the device may not be used.
 Set the subnet mask to the value 255.255.255.0.
 If necessary, switch off the proxy server in the browser in order to permit a direct connection to
the device.
 Enter the http://192.168.0.190 address in the browser (fig. 4, item 1). The login dialogue to log
in to the device will be displayed.
 Login as admin user with password admin (fig. 4, item 2).
 Click the Processing Unit entry (fig. 4, item 3) in the left-hand subarea of the overview window
(configuration area) and the Configuration tab (fig. 4, item 4) in the right-hand subarea (naviga-
tion area).
 Click the TCP/IP button in the Network group frame (fig. 4, item 5).
 Change the IP address of the device in the TCP/IP Configuration window in the IPv4 Configu-
ration group frame to an address permitted in the network (fig. 4, item 6).
 If necessary, correct the settings for the net mask and the gateway.
 Alternatively, select the "DHCPv4" setting instead of "Manual" for an automatic IP allocation.
 Click the Save button to save the settings.
 Change the network settings of your computer to their original values of the IP address and the
subnet mask.
 Disconnect the network cable to your computer.
 Connect the CMC III PU with a network cable with your Ethernet LAN (fig. 3, item 11).
To determine whether any software updates are required: see www.rittal.com or contact Rittal Serv-
ice (see section 7).
7 Service
For technical questions, please contact:
Tel.: +49(0)2772 505-9052
E-mail: info@rittal.de
Homepage: www.rittal.com
For complaints or service requests, please contact:
Tel.: +49(0)2772 505-1855
E-mail: service@rittal.de
Note:
You may need to use a cross-over cable for this purpose.
Note:
The settings for the IPv4 protocol are described below in detail. For further information
on TCP/IP configuration, please see section 1.1.
Network settings, Service

Rittal CMC III Processing Unit Specifications

General

Brand	Rittal
Model	CMC III Processing Unit
Category	Control Unit
Language	English