Using the AX-Synth’s USB port
32
Making the settings for the USB
driver
For successful USB communication, you need to specify
the USB driver you want to use, and then activate that
driver.
(1) Hold down the [SHIFT] button and press PGM
CHANGE [INC].
The display now shows the name of the driver that is
currently active (“Gen” or “Uen”) and the [WRITE]
button flashes.
(2) Keep holding the [SHIFT] button and press the PGM
CHANGE [INC] button to switch between “Gen” or
“Uen”.
(3) Press the [WRITE] button to confirm your selection.
(4) Release the [SHIFT] button.
(5) Switch the AX-Synth off, wait a few seconds, then
switch it on again.
Uen Select this if you use the supplied driver.
Gen Select this if you use a generic USB driver
included with the OS.
AX-Synth_e2 Page 32 Monday, October 12, 2009 3:41 PM
To Next Page
Loading...
Need help?
General
