18
How to Connect the GK-3
* To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the
power on all devices before making any connections.
* When connection cables with resistors are used, the volume level of equipment connected to the inputs (Normal
Pickup Input jack) may be low. If this happens, use connection cables that do not contain resistors, such as those
from the Roland PCS series.
* When all devices are properly connected, turn on the power to the various devices in the order specified below.
Turning on devices in the wrong order may result in malfunction and/or damage to speakers and other devices.
1.
Make sure that the power to the GK-
compatible device being connected is
turned off, then connect the device to
the GK-3’s GK connector using the GK
cable.
fig.2010
Connect the GK-3 only with
dedicated GK cable (supplied
with Roland GK-compatible
devices and optional GK cables
sold by Roland). Use of any other
cable may result in damage or
malfunction.
* The GK cable is a locking cable. When disconnecting
the cable, do not pull on it with undue force, but
instead release the lock and gently disconnect the
cable. You can disconnect the cable simply and
easily by holding down the locking portion with
your thumb and gently pulling on the plug.
fig.2020
GK cable
GK-compatible device
GK IN
GK-3_e.book 18 ページ ２００６年３月１３日 月曜日 午前９時２５分
To Next Page
Loading...
Need help?
General
