Roland GK-3 User Manual

7
Attaching the GK-3 to the Guitar
Confirm that the package contains all of the following parts for installing the GK-3.
fig.1010e (Accessories)
Flat-head Screw 3x16 mm
Wood Screw 3x20 mm
Spring
Double-sided tape A
Double-sided tape B
x 1 (for installing
the Controller)
x 2 (for installing
the Divided Pickup)
x 2 (for installing
the Divided Pickup)
x 3 (for installing
the Controller)
x 4 (for installing
the Divided Pickup)
Pickup Cushion
Pickup Spacer A
Pickup Spacer B
Cushion
x 4
x 2
x 3
Pickup Spacer C
x 4
x 2
x 1
Holder A
Holder B
Clearance Gauge
Screwdriver
Cap Nut
Spring Washer
Flat Washer Ø15 mm
x 1
x 1
x 1
Normal Guitar Cable
Pickup Holder
x 1
Rubber Sheet
Rubber Tube
Screw 3x8 mm
x 2
x 2
(for adjusting the height of
the Divided Pickup)
(for attaching
the Divided Pickup to
the Pickup Holder)
x 2
(for attaching
the Divided Pickup to
the Pickup Holder)
(for attaching
the Holder B)
Flat Washer Ø13 mm
(for attaching
the Holder B)
(for attaching
the Holder B)
(for attaching
the Holder A)
(for attaching
the Divided Pickup to
the Pickup Holder)
x 2
(for attaching the
Pickup Holder to the
guitar)
(for adjusting the height of
the Divided Pickup)
(for adjusting the height of
the Divided Pickup)
(for installing
the Divided Pickup)
x 2 (for installing
the Divided Pickup)
Double-sided tape C
GK-3_e.book 7 ページ ２００６年３月１３日 月曜日 午前９時２５分

Roland GK-3 Specifications

General

Type	Divided Pickup
Compatibility	Compatible with Roland Guitar Synthesizers
Connectors	13-pin Connector
Power Supply	Powered by connected GK-compatible device
Pickup Configuration	Hexaphonic Pickup
Mounting	Surface Mount on Guitar