4
Panel Descriptions
Example connections
* To prevent malfunction and equipment failure, always turn down the volume, and turn o all the units before making any connections.
Audio player MicKeyboard, Sound module etc.
MixerFootswitches
Turning the Power On/O
* Once everything is properly connected, be sure to follow
the procedure below to turn on their power. If you turn on
equipment in the wrong order, you risk causing malfunction or
equipment failure.
1. Make sure that this unit’s [MASTER] knob and the
volume of the devices connected to this unit are set
to minimum.
2. Turn on all the devices connected to the unit’s input
jacks (CH1–CH3, AUX IN).
3. Turn on the unit.
4. Turn on all the devices connected to the unit’s
output jacks (LINE OUT, PHONES).
5. Adjust the volume levels for the devices.
Before switching o the power, lower the volume on each of the
devices in your system and then turn o the devices in the reverse
order to which they were switched on.
* Before turning the unit on/o, always be sure to turn the
volume down. Even with the volume turned down, you might
hear some sound when switching the unit on/o. However, this
is normal and does not indicate a malfunction.
Setting the Volume of Each Device
In order to get optimum sound from this unit when performing,
set the volume as described below.
1. Use the [CH1]–[CH3] knobs to adjust the volume
balance of the devices connected to CH1–CH3.
2. Use the [LOW] knob and [HIGH] knob to adjust the
tone to your taste.
3. Use the [MASTER] knob to adjust the overall
volume.
If the sound is distorted, adjust the [CH1]–[CH3] knobs and
[MASTER] knob, or adjust the volume knob of the devices
connected to the inputs (CH1–CH3, AUX IN).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
