15
Apr. 2006 R-09
Exiting Test Mode
1. While in Test mode, hold down the [FINDER/MENU] button and press
the [ ] button several times to move to “12. Factory Reset.”
The next screen appears.
fig.test12-1_90
2. Press the [REC] button to execute Factory Reset.
fig.test12-2_90
When processing finishes, the screen automatically changes. If an SD
card is inserted, a screen like the one shown below appears.
fig.test13-1_90
3. Eject the SD card, and when a screen like the one shown below appears,
switch off the power.
fig.test13-2_90
When the power is off and the screen has gone completely blank, disconnect
the AC adaptor.
Skipping test items
To move among the test items, use the [ ] and [ ] buttons. If you want
to proceed to the next without executing tests for any items, hold down the
[FINDER/MENU] button and use the [ ] and [ ] buttons to make the
selection.
Test Items
In Test mode, you perform testing for the following items.
1. Checking Version
2. Device Test
3. Analog (External Mic) Test
4. Analog (LINE) Test
5. Recording and Playing
6. Switch/LED Test
7. Display Test
8. USB Test
9. Digital Out Test
10. Analog (Internal Mic) Test
11. Noise Test
12. Factory Reset
1. Checking Version
Entering Test mode displays the version-confirmation screen.
fig.test01-1_90
Prog: Program version and relevant information
Boot: Bootup program version
Updt: Update program version
After verifying the version, use the [ ] button to advance to the next item.
To Next Page
Loading...
Need help?
General
