44
Performing with the Keyboard
Performing
Changing the Keyboard’s Split Point
You can change the point at which the keyboard is divided (the Split Point)
in Split mode.
1
Hold down [SPLIT] for several seconds.
A screen such as the following appears, and the current value of the setting
is displayed.
fig.LCD
2
Hold down [SPLIT] and press a key.
When you release [SPLIT], the previous display will reappear.
The split-point key is included in the UPPER section.
Changing Tones in Layer and Split Mode
When you want to change tones in Layer and Split mode, use the PART
SELECT buttons to specify the part for which the tone is to be changed.
fig.panel
1
Press the PART SELECT button for the part whose tone you
want to change, causing the part’s indicator to light up.
The indicator for the currently selected TONE SELECT button lights up in
the same color as the indicator for the selected part.
However, the TONE SELECT buttons do not light when [NUM LOCK] is on.
2
Select the tone category with a TONE SELECT button, then
press [INC/YES] or [DEC/NO] to select the tone.
When [NUM LOCK] is on, you can specify tone numbers with the TONE
SELECT buttons (p. 37).
You can freely set the
ranges for UPPER1,
UPPER2, and LOWER as
you prefer. For details,
refer to “Setting the Key
Range for Each Part (Key
Range)” (p. 88).
CONTROL
12
RD-700_e.book 44 ページ ２００４年４月２６日 月曜日 午前１１時５４分
To Next Page
Loading...
Need help?
General
