Restoring the Factory Settings (Factory Reset)
Display Value Explanation
F18
OFF
,
10
,
30
,
240
[min.]
Making the Power Automatically Turn O After a Time (Auto O)
This species the auto-o setting.
The remaining time blinks before the power turns o. When there is less than one minute remaining, the countdown will be in seconds.
* This setting is saved automatically when you change it.
F1g
None
Saving the Settings (Memory Backup)
The settings of this digital piano will return to their default state when you turn o the power. However, you can
save the settings so they will remain unchanged even after the power has been turned o, then on again.
The display indicates “
Svr
”; press the [y] (cancel) button or the [s] (execute) button to cancel or execute.
page
11
°
Restoring the Factory Settings (Factory Reset)
The settings you’ve changed in Function mode can be restored to their factory-set condition. This operation is called “Factory Reset.”
NOTE
The “Factory Reset” operation will erase all settings stored by the Memory Backup function, as well as all songs you’ve recorded in internal
memory.
1. While holding down the [Metronome] button and the
[Split] button, turn on the power.
Keep holding down the buttons until it indicates as “
Svr
” on the
display.
To cancel, press the [y] button.
2. To execute the Factory Reset, press the [s] button.
When the Factory Reset has been completed, the display will
indicate “End.”
* Never turn o the power before the display indicates “End.”
3. Press the [L] switch to turn the power o, then on again.
°
Specifying the Maximum Volume (Volume Limit)
You can specify the maximum Volume setting. This will prevent undesirably high volumes even if the volume buttons are operated unintentionally.
1. Hold down the Volume [-] button and the Volume [+]
button, and press the [-] [+] buttons to adjust the value.
Value 20, 40, 60, 80, 100
MEMO
This setting is saved automatically when you change it.
13
To Next Page
Loading...
Need help?
General
