Rosslare AC-C31 User Manual

Return To Factory Default Settings
Warning:
You must be very careful before using this command!
Doing so will erase the entire memory which includes
all User and Special Codes, and return all codes to
their factory defaut settings.
1)
2) "0" Menu 0
3)
Enter Programming Mode
Press to enter
The Mode LED will flash red
The Door LED will flash red
Enter your 4-digit Programming
Code.
If the Programming Code is valid, all memory will be erased,
you will hear three beeps and the controller will return to
Normal Mode
If the Programming Code is invalid you will hear a long beep
and the controller will return to Normal Mode without erasing
the memory of the controller.
!
!
!
!
Page 28
06/01
AC-C31
Page 29
06/01
Replacing a lost Programming Code
Replacing a lost Normal / Secure Code
1)
2)
3)
4)
5)
1)
2)
3)
4)
5)
Remove power from the AC-C31
Press the REX button
Apply power to the unit with REX button pressed
Release the REX button
You now have 15 seconds to program a new Programming Code
into the unit using the initial default code 1234, before the
controller reverts to the existing code.
Remove power from the AC-C31
Press the REX Button
Apply power to the unit with REX button pressed.
Release the REX Button
You now have 15 seconds to program a new Normal / Secure
code into the unit using the initial default code 3838, before the
controller reverts to the existing code.
Note:
Note:
The AC-C31 must be in Normal Mode otherwise this will
not work. Make sure that the Mode LED is green before
proceeding.
The AC-C31 must be in Secure Mode otherwise this will
not work. Make sure that the Mode LED is red before
proceeding.
AC-C31
Mode Door
GREEN
Mode Door
RED
RED
?
?
?
?

Rosslare AC-C31 Specifications

General

Brand	Rosslare
Model	AC-C31
Category	Control Unit
Language	English