To Next Page

To Previous Page

CARAFE

• The bottom of the carafe will be hot, set it down on an insulated mat.

• Rinse the carafe with hot water, to prewarm it, so it doesn’t take heat from the coee.

• To remove the lid, turn it to align the U with the u.

• Replace the lid in the same position, then turn it to align the L with the u.

• To open the spout for pouring, press the lever at the rear of the lid.

USING THE TIMER

Note: Make sure the clock is set to the correct time. Use the hr and min buttons.

1. Prepare the coee maker according to which mode you are using but do not press the + button to start brewing.

2. Press the

button. The button will ash and the

icon will ash on the display.

3. Within 10 seconds of pressing the

button, use the hr and min buttons to enter the time you want your coee maker to start brewing.

4. If a time has previously been programmed, it will ash on the display otherwise the display will show the default setting of 8:00.

5. 10 seconds after you have nished entering the time, the

button will stop ashing and remain lit. The

icon on the display will also stop ashing

and remain lit. Your coee maker is now programmed to brew at the time you have entered.

• If you want to check the program time press the

button. The programmed time will show for 3 seconds and then return to the time of day.

• If you want to cancel the timer before brewing has started, press and hold the

button for 5 seconds until the

light goes out and the

icon

disappears from the display.

• If you want to stop the coee maker while it’s brewing, press the + button.

A QUICK CUP

If you want a quick cup of coee before the brewing cycle has nished:

1. You can remove the carafe at any time. The non-drip valve will prevent coee dripping on to the hotplate.

2. To prevent the lter holder overowing, replace the carafe on the hotplate within about 20 seconds.

3. When you replace the carafe on the hotplate the non-drip valve opens to let any remaining coee through.

CARE AND MAINTENANCE

GENERAL CLEANING

1. Unplug the appliance and let it cool.

2. Tip the contents of the lter holder into the bin.

3. Wipe all surfaces with a clean damp cloth.

4. Hand wash the carafe and lter holder. Wipe out the hopper with kitchen paper.

5. Wipe the shaded area shown in Fig H with a piece of damp kitchen paper. Use the brush if necessary to loosen any coee debris.

Note: If you haven’t used your coee maker for more than 4 weeks, we recommend that you follow the steps under BEFORE USING FOR THE FIRST TIME

before brewing coee again.

CLEANING THE GRINDER

The grinder can be disassembled in order to clean it. If you try to disassemble the grinder without rst removing any surplus coee beans, it will be very

dicult to reassemble correctly. Follow these steps:

1. Twist the coee bean hopper and lid counterclockwise until the d symbol aligns with the usymbol (Fig A).

2. Lift o the hopper, remove the lid and empty out any coee beans. Wipe out the hopper with kitchen paper.

3. Replace the lid then ret the hopper onto the coee maker aligning the d symbol with the usymbol. Twist the hopper clockwise until the d

symbol aligns with the lsymbol (Fig B).

4. Turn the grind control to the ne (l) setting.

5. Press the

button to select the 6 cup setting.

6. Press the + button. After a few moments the grinder will start. Once it has stopped, press the + button until the +light goes out.

7. Follow step 1 again to remove the bean hopper.

8. Turn the grind control to the

setting (Fig C).

9. Lift up the handle on the grinding head (Fig D).

10. Lift the grinding head out of the body of the appliance (Fig E). If it doesn’t lift out easily, make sure that the 3 marks on the grinding head are aligned

with the b markings (Fig G).

11. Use the cleaning brush to clean the grinding head and the area where it ts into the appliance. Do not use water.

12. Ret the grinding head by aligning the 3 marks on the grinding head with the b markings and pressing it down (Fig G). Fold the handle back down.

13. Turn the grind control to any of the grind settings.

14. Ret the hopper.

SELF CLEAN

After 60 brewing cycles, the display will show CLE and the c icon to indicate that the appliance needs descaling. Descaling ushes out the deposits that

naturally build up over time.