11
ASSEMBLY
UNPACKING
This product requires assembly.
Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this tool until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
Fig. 5
Miter Gauge
Hex Key
Worktable
Work Support
Operator’s Manual (not shown)
LOOSE PARTS
The following items are included with the tool:
Sanding Disc
Disc Guard
Phillips Screws (2)
Socket Head Screws, M8 x 12 (2)
Washers (2)
SANDING DISC
MITER GAUGE
WORK
SUPPORT
SOCKET HEAD
SCREWS
DISC GUARD
WORKTABLE
HEX KEY
WASHERS
PHILLIPS
SCREWS
To Next Page
Loading...
Need help?
General
