13
Deutsch(Übersetzung der originalen Anleitungen)
DE
FR EN ES IT PT NL SV DA NO FI HU CS RU RO PL SL HR ET LT LV SK BG
13
English(original instructions)
EN
FR DE ES IT PT NL SV DA NO FI HU CS RU RO PL SL HR ET LT LV SK BG
TROUBLESHOOTING
Line will not advance
when you restart the
machine.
1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
1. Lubricate with a silicone spray.
2. Install more line (Refer to “Replacing the Cutting
Line” earlier in this manual).
3. Pull lines while pressing release button (17).
4. Remove line from spool and rewind (Refer to
“Replacing the Cutting Line” earlier in this manual).
Cutting head is hard to
turn.
Grass wrapped or built up
around head.
Clean affected parts of the machine.
Grass wraps around the
out put shaft and the
trimmer head assembly.
Cutting tall grass at ground
level.
Cut tall grass from the top down.
Line trimmer stops and will
not start again
1) Unit failed
2) Plug is damaged.
1) Contact dealer to check damage
2) Check the plug
DISPOSAL
This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
RLT5030S 23lgs manual.indd 13RLT5030S 23lgs manual.indd 13 2009/11/16 3:442009/11/16 3:44
To Next Page
Loading...
Need help?
General