CAUTION:
Use of controls or adjustments or performace of procedures other than those specied herein may result in
hazardous radiation exposure.
Laser type: Semiconductor
Laser class: 2
Wave length: 650NM
Power supply: 3V
Laser power: < 1 mW
For service personnel.
CAUTION:
Avoid exposure to beam when servicing.
Complies with AS2211.1.1997 as a Class 2 Laser.
The laser shall be used and maintained in accordance with the manufacturer’s instructions.
Never aim the beam at any person or an object other than the workpiece.
The laser beam shall not be deliberately aimed at personnel and shall be prevented from being directed
towards the eye of a person for longer than 0.25s.
Always ensure the laser beam is aimed at a sturdy workpiece without reective surfaces, i.e. wood or
rough coated surfaces are acceptable. Bright shiny reective sheet steel or the like is not suitable for laser
use as the reective surface could direct the beam back at the operator.
Do not change the laser light assembly with a different type. Repairs must be carried out by authorised
Ryobi service centre.
Page 5
RULES FOR SAFE OPERATION
Warning:
Do not stare directly at the laser beam.A hazard may exist if you deliberately stare into the beam, please
observe all safety rules as follows.
LASER LIGHT. LASER RADIATION
Do not stare into beam.
Only turn laser beam on when tool is on
work piece.
Class 2 laser product
To Next Page
Loading...
Need help?
General
