To Next Page

To Previous Page

MAINTENANCE

REPLACING THE BLADE

WARNING: To reduce the risk of injury, keep

the blade protector on the blade at all times.

Remove the blade protector only during

cutting operations.

1. Turn o󰀨 the product, and allow it to cool

down.

2. Place the combination wrench through the

hole in the upper ange washer and the hole

in the gear head.

Using the wrench, turn the blade retainer nut

clockwise half a turn from finger-tight.

Remove the cupped washer, blade washer,

and ange washer, and then remove the

blade from the upper ange washer.

3. Place the upper ange washer over the gear

shaft with the hollow side towards the blade

guard.

Centre the blade on the upper ange washer,

and make sure that the blade sits at.

Install the blade washer and cupped washer

with the raised centre away from the blade,

and make sure it sits well into the gear shaft.

Install the blade retainer nut until nger-tight.

Place the combination wrench through the

hole in the upper ange washer and the hole

in the gear head.

Using the wrench, turn the blade retainer nut

counterclockwise at least 4 turns from nger-

tight.

25 Nm

Ryobi RBC254SESO User Manual

Other manuals for Ryobi RBC254SESO