H1 Series
(6) After settings, users can move to set the Export Limitation Setup on
the hybrid inverter.
Select the “Setting” in menu, press ENT to the second menu, then select
“Mode Setting”, press ENT to enter the interface of choosing Export
Limitation Setup, as shown below
Figure 5.17 Mode Setting
Note: Meter is not waterproof or dust-proof, it is recommended to install it
in the distribution box. If the current value showed in the meter is a
negative value, the export limitation is working.
2019-09-16 18:26:31
Graph Setting Run-Info About
ON OFF
Meter eanble:
OK
Meter Addr: 1
Export limit enable:
ON OFF ON OFF
To Next Page
Loading...
Need help?
General
