9
GB
USING YOUR NEW CONTROL CENTRE
The following procedures show how to operate the control centre. It
is recommended that you follow the instructions and try to operate
once before connecting it to the heating or cooling system.
1, Start
There is a sliding door on the right half of the thermostat. If you open
the door, you can see some buttons. This door is removable for the
replacement of batteries. After opening the door, you can ip the door
up or down to see the battery compartment.
The control centre is operated by two AA alkaline batteries. Please
remove the front cover and install two new batteries.
When the batteries are installed, the control centre should be
operating and you can see the LCD active. If the control centre does
not work properly, please check the batteries for wrong polarities and
press the reset button by using a ball-point pen.
The LCD after start or reset:
To Next Page
Loading...
Need help?
General
