Installation – parameter setting
VS05 Installer Manual 13
FUNCTION DESCRIPTION DEFAULT
Valve Exercising
PWM
PROBE
Actuator
Setback
ON
ON
ON
ON
ON
If the installer setting is to enable the valve exercising the dial thermostat will
additionally send 5 minute pulse on actuator once a week, 24 hours- 7 days.
PWM output to drive actuator open/close
Need help
Actuator can be normally closed/normally open.
Subject to installer jumper selection
Need help
1
2
Parameter setting
Floor sensor temp
(optional)
If you are tting an external
sensor for air/oor sensing
please select temp here. It can
be set from 0-45 and as preset
at 27. Please note the dip
switches (2) need to be set for
Air or Floor.
To Next Page
Loading...
Need help?
General
