29
ENG
Selecting the Sound Mode (depending on the model)
The “DUAL
I-II”
button displays/controls the processing and output
of the audio signal. When power is switched on, the mode is
automatically preset to either “Dual-I ” or “Stereo”, depending on
the current transmission.
➣
◆ If the receiving conditions deteriorate, listening will be
easier if the mode is set to the
Mono.
◆ If the stereo signal is weak and an automatic switching
occurs, then switch to the
Mono.
◆ When receiving a mono sound in the AV mode, connect
to the “AUDIO-L” input connector on the panel (front or
side). If the mono sound comes out only from left
speaker, press the
DUAL
I-II
button.
Type of broadcast
Regular broadcast
(Standard audio)
Regular +
NICAM Mono
NICAM Stereo
NICAM Dual-I/II
Regular broadcast
(Standard audio)
Bilingual or Dual-I/II
Stereo
On-screen indication
Mono
(Normal use)
Mono ↔ Mono
NICAM (Normal)
Stereo ↔ Mono
NICAM (Normal)
Mono (Normal use)
DUAL-I ↔ DUAL-II
Stereo ↔ Mono
(Forced mono)
Dual-I → Dual-II → Mono
NICAM NICAM (Normal)
NICAM
Stereo
A2
Stereo
→
→
AA68-03418A-00Eng_UMG_TM76 6/2/04 11:49 AM Page 29
To Next Page
Loading...
Need help?
General