Setting a Supervisor Password
A Supervisor Password is required to turn
the computer on or to start the System
Setup.
When setting a Supervisor Password, users
other than a supervisor cannot use the
computer.
1
Select the
Security
menu in the BIOS
Setup.
2
In the
Set Supervisor Password
item,
press <
Enter
>.
3
Enter a password, press <
Enter
>, re-
enter the password for conrmation,
and press <
Enter
> again. The
password can be up to 8 alphanumeric
characters. Special characters are not
allowed.
4
The supervisor password has been set.
The supervisor password is required to
turn the computer on or to enter the
BIOS Setup.
For some models, if the password
entered message appears in the
Setup Notice
window, the settings
are not complete until the
Enter
key
is pressed.
Setting a User Password
Users can start the system with a user
password, but cannot enter the System
Setup. By doing this, you can prevent other
users from entering Setup.
Setting a Boot Password
When setting a password, you have to enter a password to use the computer or enter the
BIOS Setup.
By conguring a password, you can restrict system access to authorized users only and
protect data and les saved on the computer.
Before You Start!
Do not lose or forget your password.
If you have forgotten your password, contact a Samsung service center. In this case, a
service fee will be charged.
To Next Page
Loading...
Need help?
General