English - 43
The IR Blaster
When you connect an IR Blaster with your TV, you can control connected external devices with your TV
using the Smart Touch Control.
✎
If you control an external device by using the Smart Touch Control, the IR Blaster sends an IR signal
into a corresponding external device.
✎
Install the IR Blaster within 50 cm and 45 degrees of the up, down, left and right directions of the IR
sensor of the external device.
IR Blaster
OPEN
ON
OFF
PAIRING
OPEN
1
1
2
1. Hold the both sides of the battery holder and pull it out.
2. Install four batteries so that the polarity of the batteries (+/-) matches the illustration in the battery
compartment.
3. Push it back.
[UE8000-ZA]BN68-04495A-00Eng.indb 43 2012-10-11 �� 1:16:56