1 31 3
1 41 4
11
22
33
HOW TO USE PRESET WASHING HOW TO USE PRESET WASHING
·The preset time means the ending time of washing.
·Before using Preset Washing, please make sure of opening water supply, drain hose to
avoid water leakage.
1.Press POWER ON/OFF button .
2.Select COURSE or PROCESS as needed.
3.Press the PRESET button to select the time of ending.
4.Select water level if necessary.
·Putting detergents.
5.Close the washer lid.
6.Press the START/PAUSE button.
·After the PRESET is started, the corresponding light will be turned on, and
other lights get turned off around one minute latter.
·Preset function could not be used for DELICATE course.
·To check the Preset procedure, please press PRESET button, the procedure
will be indicated for 5 seconds.
·To cancel the preset, please shut off the power.
·To change the preset time, please re-preset after cancel of it.
THREE TYPES OF RINSETHREE TYPES OF RINSE
1.Water Saver Rinse(Normal)
2.Shower Rinse(Water Saving)
3.Overflow Rinse(with excessive detergents)
When spin finished, water is added
to the level setting and the washer
starts rinsing.
The Wash/Spin tub will start rotating slowly
while water is added like shower. The water
continuous to drain during this cycle.
Water is added to the level setting after spinning,
then the washer starts rinsing. During this operation,
the water still is added continuously to overflow the
foam with detergents.
VARIOUS FUNCTIONSVARIOUS FUNCTIONS
ULTRASONIC FUNCTIONULTRASONIC FUNCTION
When select ULTRASONIC function, the light of ULTRASONIC is flashes. The washer
will brings Ultrasonic during working, and this helps more clean washing and saving
detergents.
·Please use less detergents or wash powder when select ULTRASONIC function.
·Cancel method of ULTRASONIC function: Press POWER ON/OFF button to switch on
the power, and press WASH button for 4 seconds till a sound from buzzer. To restore it,
repeat above or pull out the plug.
MULTIPLE WATER POWER FUNCTION MULTIPLE WATER POWER FUNCTION
Press WATER POWER button to adjust water current during washing or rinsing. Press it
once more, the digital indicates “ H0 (standard water power), H1, H2, H3, H4, ( stronger.
H4 is the strongest); L1, L2, L3, L4 (weaker, L4 is the weakest).
And this function could not be set for DELICATE or BLANKET program.
HOW TO USE DETERGENT WHEN PRESET WASHHOW TO USE DETERGENT WHEN PRESET WASH
·You can put powder detergent directly to Detergent Tray or put it directly to wash
tub wrapped with handkerchief.
·Pour liquid detergent or bleach to the hole on pulsator. Do not pour it directly to
laundry, otherwise possibly cause depigmentation.
·Dilute the Softener with twice water, pour it into Softener Dispenser on the balance
ring.
·Do not use Soap since it is difficult soluble.
Procedure
To Next Page
Loading...
Need help?
General
