34 S4179694
4-2. Mounting on a Wall (KS2432A only)
(a) Removable mounting
(1) Confirm the indoor unit beeps when the ON/
OFF button is pressed at the wall location
where the remote control unit is to be
attached, then attach the holder to the wall.
(Fig. 4-3)
(2) When taking out the remote control unit, pull
it from the holder.
When using the remote control unit
● Point the transmission portion of the remote
control unit at the receiver area of the indoor
unit when operating the remote control unit,
and during operation of the air conditioner.
● Do not place objects that may block the
transmitted signals between the receiver and
the remote control unit.
(b) Non-removable mounting
(1) Mount the holder to the wall with one of the
screws (using only the hole in the top of the
holder) (Fig. 4-4).
(2) Remove the cover of the remote control unit
and take out the batteries. Next, place the
remote control unit in the holder.
(3) Fasten both the remote control unit and
holder to the wall with the remaining screw
(using the hole in the bottom of the holder).
(4) Install the batteries in the remote control unit
and close the cover.
2257_M_I
Holder
Holder
Truss-head
tapping screw
5/32 × 5/8" (4 × 16mm supplied)
Fig. 4-4
Fig. 4-3
2256_M_I
Truss-head
tapping screw
5/32 × 5/8" (4 × 16mm supplied)
Remote
control
unit holder
To Next Page
Loading...
Need help?
General
