4 Use your TV
Switching on your TV and putting it in
Standby mode
To Turn the TV On from Standby or Off to Standby
●
Press B on the Side of the Unit or the Remote Control.
Note(s)
●
Energy Consumption contributes to air and water pollution. When the AC Power Cord is
plugged in, your TV consumes energy with a very low Standby Power Consumption.
Adjusting Volume
To decrease or increase Volume
●
Press VOL J (–) / K(+) on the Side of the Unit or press VOL H / I on
the Remote Control.
VOL J (–) / I : Volume Down
VOL K (+) / H : Volume Up
To mute or unmute sound
●
Press D on the Remote Control to mute the sound.
●
Press D again or VOL H / I to recover the original sound.
Switching Channels
To select Channels by using CHI / H or CH + / –
●
Press CH I(–) (Down) / H(+) (Up) on the Side of the Unit or press CH
+ / – on the Remote Control.
To select Channels by using the NUMBER keys
●
For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
–
When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
–
When selecting Cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
●
To select the non-memorized channels, use the NUMBER keys.
●
No signal will appear on the TV screen after the subchannel broadcast is over.
●
Audio only program message will appear on the TV screen, when you receive only a sound
signal.
16 .English
Continued on next page.
To Next Page
Loading...
Need help?
General
