These operations are accessible by remote control.
Some may also be accessible by the main unit's control panel.
Initial setup
This section will guide you through the unit’s Initial setting which
includes selecting a language for your on-screen menu, country,
location and Autoprogram, which automatically scans and
memorizes viewable channels. You can also set the network
connection in this setting.
Before you begin:
Make sure the unit is connected to an antenna or cable.
1
After making all the necessary connections, press B to turn on
the unit.
●
It may
take a few moments to turn on the unit for the first time.
●
Initial setup menu appears automatically after the unit is
turned on.
2
Use H I to select the on-screen language, Voice guide, country,
TV placement and location in the middle of the TV screen, then
press OK.
●
You must set Home in location setting. Otherwise, Picture
and Sound settings you adjusted will not be memorized after
the unit goes into standby mode.
3
Use J K to select Skip or Next on network setup screen.
4
Use H I to select Wireless or Wired, then press OK.
12 34 756
Skip
Wired
Wireless
Installation
Select your connection type.
This TV can be connected to your
home network.
Wireless
If you have a wireless router, select Wireless to
connect to the internet.
Wired
If you connect with an Ethernet cable, select
Wired to connect to the internet.
●
If you have a router with easy connect function, select
Wireless and use
J
K
to select Simple Connect, then press
OK.
5
Follow the on-screen instructions to complete the installation.
●
When you select On in the selection screen for Software
update notification,
A
message will appear later if there is the
latest software on the network server.
6
Use H I to select the signal type.
●
If the
TV is connected to a cable or satellite set-top box, select
the 2nd one and skip to step 8.
12 34 756
Installation
Set-top box
Select "Set-top box" to set up a TV
signal from a cable TV box or
satellite TV receiver.
Antenna
Select "Antenna" to set up a TV
signal from a cable TV wall jack or
a standard TV antenna.
7
Use H I to select Antenna for TV channels or Cable for CATV
channels, then press OK.
12 34 756
Installation
Skip
Cable
Antenna
Now select either Antenna or
Cable, using up/down key of the
remote control. Once you have
made your selection, press the OK
button to proceed.
Make sure that you have attached
your antenna or cable signal into
the jack on the back of your TV
labeled "ANTENNA IN".
–
When Antenna is
selected, the TV detects antenna signals.
It searches for DTV and analog TV channels available in your
area.
–
When Cable is selected, the TV detects signals supplied by
cable. It searches for DTV, analog TV and cable channels
available in your area.
●
Auto programming will begin.
0
0
12 34 756
Installation
Stop
Total progress:
Analog channels found:
Digital channels found:
Please wait until you see the Auto
Programming complete message.
Digital channels will take longer
than Analog to find and program.
Auto programming may take more
than 20 minutes to complete.
System searching. Please wait…
20 .English
Continued on next page.
To Next Page
Loading...
Need help?
General
