EasyManuals Logo
Home>Sanyo>Projector>PLC-SU50

Sanyo PLC-SU50 User Manual

Sanyo PLC-SU50
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
Part Names and Functions
To insure safe operation, please observe the following precautions :
Use (2) AA, UM3 or R06 type alkaline batteries.
Replace two batteries at the same time.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not expose the remote control to moisture, or heat.
Do not drop the remote control.
If a battery has leaked on remote control, carefully wipe case clean and install new batteries.
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Press the lid down-
ward and slide it.
Remove the battery
compartment lid.
Slide the batteries into
the compartment.
Replace the compartment
lid.
Two AA size batteries
For correct polarity (+ and
–), be sure battery
terminals are in contact
with pins in compartment.
12 3
Point the remote control toward the projector (Infrared Remote Receiver) whenever pressing any button. Maximum
operating range for the remote control is about 16.4’ (5m) and 60° in front of the projector.
16.4’
(5 m)
60°
Remote Control Batteries Installation
Remote Control Operating Range

Table of Contents

Other manuals for Sanyo PLC-SU50

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLC-SU50 and is the answer not in the manual?

Sanyo PLC-SU50 Specifications

General IconGeneral
BrandSanyo
ModelPLC-SU50
CategoryProjector
LanguageEnglish

Related product manuals