Operation without the Remote
Control Unit
Care and Cleaning
1. For safety, be sure to turn the air conditioner off and also to
disconnect the power before cleaning.
2. Do not pour water on the indoor unit to clean it. This will damage the
internal components and cause an electric shock hazard.
Casing and Grille (Indoor Unit) Clean the casing and grille of the indoor unit with a vacuum cleaner brush, or
wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with a mild liquid
detergent. When cleaning the grille, be careful not to force the vanes out of
place.
1. Never use solvents, or harsh chemicals when cleaning the indoor
unit. Do not wipe the plastic casing using very hot water.
2. Some metal edges and the fins are sharp and may cause injury if
handled improperly; be especially careful when you clean these
parts.
3. The internal coil and other components of the outdoor unit must be
cleaned every year. Consult your dealer or service center.
CAUTION
01_SAP-KRV93EHFP_EN.fm Page 22 Tuesday, November 15, 2005 1:18 PM
If you have lost the remote control unit or it has trouble, follow the steps
below.
1. When the air conditioner is not running
If you want to turn on the air conditioner, switch the operation selector to
the OFF position, and then to the ON position.
NOTE The set temperature and fan speed are automatically set at the
last selection before stopping.
2. When the air conditioner is running
If you want to turn off the air conditioner, switch the operation selector to
the OFF position.
MODELS XRV
TEST
OFF
ON
MODELS FTRV
MODELS FRV
MODELS URV
25
To Next Page
Loading...
Need help?
General
