18
Receiver installation and electrical wiring
Receiver installation
Open the receivers housing by unscrewing the screw on the top of the case (1). Now carefully open the housing from
the front side (2). Install the housing on a wall with included screws. (3). Now, do the electrical wiring. After you’ve
connected all the wires, close the housing and put the top screw back in its place (4)
Tip: Do not mount the receiver on a metal surface, very close to metal objects and other electrical devices, as there
can be interference in wireless communication between the receiver and the thermostat. Also, the RF 100m range is
defined as theoretical nature, and in practice this is influenced by a huge number of factors (from type of house, other
wireless devices, electrical appliances, …) so be careful to mount the receiver in a position where it can normally
communicate with the thermostat. The devices uses top quality electrical elements but yet, we cannot influence on all
factors.
To Next Page
Loading...
Need help?
General
