Sceptre X32 Series User Manual

- 21 -
www.SCEPTRE.com
SCEPTRE E325 HDTV User Manual
Connecting to a PC with VGA and 3.5 mm minijack …
1. Make sure the power of HDTV and your PC is turned off.
2. Obtain a 15-pin D-Sub VGA cable; connect to the VGA output of your PC and the other end to
the VGA port on the back of your
HDTV.
3. Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC and the other end to the VGA
Stereo Input port.
4. Turn on the power of the
HDTV and your PC.
5. Use the remote control’s source button or the source button on the TV to switch to PC.
6. Change your PC resolution to 1360x768 at 60hz refresh rate.
7. Press MENU to use the OSD’s PICTURE option.
8. Under the PICTURE option select PC Settings.
9. Under PC Settings use AUTO ADJUST to adjust the screen.
Please Note:
• For the best results, please set your PC resolution to 1360x768 at 60 Hz. Please
refer to the PC or graphic card’s manual for further instructions on how to set your
resolution and refresh rate.
• Please refer to your PC manual for video output requirements of the video card.
• The VGA port of the TV features a power saving mode which will automatically turn
off the TV, if there’s no signal provided for more than 5 minutes.

Sceptre X32 Series Specifications

General

Brand	Sceptre
Model	X32 Series
Category	TV
Language	English