9
DISPLAY AND ERROR MESSAGES
The machine is turned off and the background of the
display is dark. The product buttons don’t work. There is
no power to the boilers. To turn the machine on, press
the on/off button.
This message should appear when you turn on the
machine after it has been in ‘standby’ mode for a while.
It takes approx. 5 minutes for the machine to heat up. If
message persists, call for service.
The machine is ready for dispensing. The product
buttons are ready for use (select). The lower left corner
indicates the time (military) and the lower right hand
corner indicates the date (day.month.year).
The display prompts this message when the machine
has been dispensing a preset (programmable) number
of beverages without a cleaning. The only way to clear
this message from the display is by initiating the cleaning
program.
When you first press the cleaning program button to
initiate the cleaning cycle, the display prompts you to
remove the grounds bin. You need to do this
immediately.
After you remove the grounds bin in the cleaning
program, the machine reminds you to use the cleaning
brush to wipe out any excess coffee grounds from the
brew group and the bottom of the brew area.
In the cleaning program, after you use the brush, and
slide the grounds container back in place, the machine
will prompt you that you may now insert the Schaerer
cleaning tablet in the tablet opening.
This message appears while the cleaning program is
running. During the cleaning cycle all product buttons
are locked out. The machine can be used again when
“select beverage” appears on display. If message
persists for more than 5 minutes, call for service.
This message appears during the quick flush, initiated by
pressing and holding the cleaning button for 5 seconds.
09:04 01.01.2000
heating
selection locked
clean machine
remove container
use brush
insert tablet
09:04 01.01.2000
To Next Page
Loading...
Need help?
General
